Hilti X-PT 5, Manual

Page: 7 / 30

English 1
1 Overview of the items available
1.1 Technical description 1
Item Description Length Weight
A Pole tool 2.16 m (7 ft) 2.1 kg (4.63 lb)
B Pole tool 1.55 m (5 ft) 1.8 kg (3.97 lb)
1 Tool holder
Total length with DX 5 tool: ?
0.51 m (1 11/16 ft) 0.8 kg (1.76 lb)
2 Tubular section 0.93 m (3 ft) 0.7 kg (1.54 lb)
3 Tubular section 0.31 m (1 ft) 0.3 kg (0.66 lb)
4 Grip section 0.48 m (1 9/16 ft) 0.7 kg (1.54 lb)
1.2 Selection table
Item Part No. of parts in
version
1.52 m (5 ft)
No. of parts in
version
2.13 m (7 ft)
No. of parts in
version
3.05 m (10 ft)
No. of parts in
version
3.96 m (13 ft)
­ Tool holder 1 1 1 1
2 Tubular section 0.9144
m (3 ft)
­ 1 2 3
3 Tubular section 0.348 m
(1 ft)
1 ­ ­ ­
4 Grip section 1 1 1 1
1.3 Malfunctions and troubleshooting
Possible malfunction Remedy (after lowering the tool)
The tool doesn’t fire. Check that the tubular sections are screwed in as far as they
go.
The cartridges are not transported. Pull the cartridge strip through manually to the next cartridge.
2 Manufacturer's warranty
Hilti warrants that the tool supplied is free of faults in material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned and serviced in accordance with the Hilti operating
instructions and the technical system is maintained. This means that only genuine Hilti consumables,
components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or replacement of defective parts only over the entire lifespan
of the product. Parts requiring repair or replacement as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent national regulations prohibit such exclusion. In particular,
Hilti accepts no liability for direct, indirect, incidental or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inability to use the product for any purpose. Implied
warranties of merchantability or fitness for a particular purpose are specifically excluded.
For repair or replacement, send the tool or appliance or related parts immediately upon discovery of the fault
to the address of the Hilti marketing organization responsible.
This constitutes Hilti ’s entire obligation with regard to warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning warranties.
3 Assembly
3.1 Assembling the tubular sections and tool holder 2
Screw the tubular sections and tool holder together, tightening the joints by hand only, without use of tools.
Printed: 30.03.2017 | Doc-Nr: PUB / 5341687 / 000 / 00