6
It is essential that the safety precautions printed in these
operating instructions are read and observed.
G
Disconnect the plug from the mains socket.
G
Check that the saw blade is mounted securely and that
it runs freely.
G
Check all safety equipment for correct functionality.
If extension cords are used: only extension cords of a
type approved for the intended use and of adequate cross
section may be used. Failure to observe this point may
result in reduced performance of the tool and over heat-
ing of the cord. Check the extension cord for damage at
regular intervals. Damaged extension cords must be
replaced.
Recommended minimum cross sections and max. cord
lengths:
Extension Cord Table
Volts
Total Length of Cord in Feet
120 V
0–25
26– 50
51–100
101–150
240 V
0–50
51–100
101–200
201–300
Ampere Rating
AWG
More Than
Not More Than
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not recommended
Extension cords for outdoor use
For outdoor work use only extension cords approved and
correspondingly marked as suitable for outdoor use.
Pay attention at all times
Always concentrate on the job. Proceed carefully and do
not use the tool if you are distracted from your work.
8. Operation
7. Assembly
- CAUTION -
I
The cutting edges of the saw blade
are sharp.
I
The cutting edges may present a risk
of injury.
I
Wear protective gloves.
filter out microscopic particles and direct dust away
from the face and body. Avoid prolonged contact with
dust. Wear protective clothing and wash exposed areas
with soap and water.
Allowing dust to get into your
mouth, eyes, or to remain on your skin may promote
absorption of harmful chemicals.
Electrical
G
Concealed electric cables or gas and water pipes pre-
sent a serious hazard if damaged while you are work-
ing. Accordingly, check the area in which you are work-
ing beforehand, e.g. by using a metal detector.
G
External metal parts of the tool may become live, for
example, when the saw cuts inadvertently into an elec-
tric cable.
G
Do not touch the supply cord if it has become dam-
aged while working. Disconnect the supply cord plug
from the mains socket immediately.
G
Dust or dampness on the surface of the tool make it
slippery and difficult to hold and may, under unfavourable
conditions, present a risk of electric shock.
Conditions to be fulfilled by the user
G
The tool is designed for professional use.
Personal protective equipment
Protective devices
Do not switch on the tool when the saw blade, the blade
guard, the pivoting guard are not fitted correctly.
G
The pivoting guard must be able to move freely. It must
not be fixed in an open position.
Symbols used on the tool:
V volts
n
0
no load speed
~ alternating current
/min revolutions per minute
Hz hertz
∅
diameter
A amperes
Z
double insulated
6. Functional description
The WSC267-E is an electrically powered hand-held tool
designed for the sawing of wood, plastics and composite
materials by professional users.
The following items are supplied: power tool with saw
blade, operating instructions, pivoting chip ejector and
toolbox.
- CAUTION -
I
The cutting edges of the saw blade
are sharp.
I
The cutting edges may present a risk
of injury.
I
Wear protective gloves.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071326 / 000 / 00