Hilti VC 300-20-W, Original Operating Instructions

Page: 11 / 52

*2333434*
2333434 English 7
VC 300-20-W
Max. vacuum 3.0 psi
(20.8 kPa)
Container capacity
20 liq. gal
US
(75 ℓ)
Water capacity 14 liq. gal
US
(52 ℓ)
Operating temperature
32 ℉ … 104 ℉
(0 ℃ … 40 ℃)
Filter cleaning manual
AC frequency 50 Hz … 60 Hz
Mains connection (type) SJTW-A 3×14 AWG
Protection class I
Protection class IPX4
5 Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via
a link, in the form of a QR code, at the end of this document.
6 Before use
DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected to the
electric supply.
▶
Connect the vacuum cleaner only to a properly earthed/grounded power source.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may run
away out of control if the wheel brakes are not engaged.
▶
Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1 Operating the appliance for the first time
1. Open the two catches.
2. Lift the suction head off the waste material container.
3. Remove the accessories and packaging from the waste material container.
4. Set the suction head on the waste material container and close the two catches.
5. Check to ensure that the vacuum cleaner top section is fitted correctly and secured.
6. Connect the suction hose to the appliance.