Hilti TE SX, Original Operating Instructions, Page: 14 / 37

10
Technical data
Rated power 500 W
Nominal voltage * 100 V, 110 V, 120 V, 220 V, 230 V, 240 V
Nominal current input * 5.3 A, 4.8 A, 4.6 A, 2.4 A, 2.3 A, 2.2 A
Frequency 50–60 Hz
Weight as per EPTA-Procedure 01/2003 2.8 kg
Dimensions (l
×
h
×
w) 340
×
210
×
76 mm
Minimum distance between wall and hole drilled 38 mm
Speed Automatic function ON 700 /min
Automatic function OFF 900 /min
Single impact energy Automatic function ON 0.7 j
Automatic function OFF 1.0 j
Hammering speed under load 4680/min.
* The tool is offered in different versions for various nominal voltages. Please refer to the information on the
type plate for the nominal voltage and nominal current input of your tool.
-NOTE-
The vibration emission level given in this information sheet has been measured in accordance with a standardised
test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary asses-
sment of exposure. The declared vibration emission level represents the main applications of the tool. However if
the tool is used for different applications, with different accessories or poorly maintained, the vibration emission
may differ. This may significantly increase the exposure level over the total working period. An estimation of the
level of exposure to vibration should also take into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly reduce the exposure level over the total working peri-
od. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organisation of work patterns.
Noise and vibration information (according to EN 60 745)
Typical A-weighted sound power level 88 dB(A)
Typical A-weighted emission sound pressure level 99 dB(A)
For the given sound power level as per EN 60745, the tolerance is 3 dB.
Wear ear protection!
Triaxial vibration value (vibration vector sum)
measured in accordance with EN 60745-2-6 prAB: 2005
Hammer drilling in concrete, (a
h, HD
) 14.0 m/s 2
Uncertainty (K) for triaxial vibration value
1.5 m/s 2
Main features of the tool
Electrical protection class II (double insulated) Z
Radio and TV interference suppression as per EN 55014-1
Immunity to interference as per EN 55014-2
Slip clutch overload protection
No-load hammering absorption
Vibration-absorbing side handle
Quick-change chuck
TE SX connection end
Automatic function selector switch – full power (OFF) and reduced power (ON)
Drilling mode
Gearing and hammering mechanism with permanent lubrication
Automatic cut-out carbon brushes
Adjustable side handle
Right of technical changes reserved
Printed: 07.07.2013 | Doc-Nr: PUB / 5136127 / 000 / 00