Hilti TE 800, Operating Instructions Manual

Page: 21 / 180

*2064795*
2064795 English 17
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle 2
CAUTION
Risk of injury! Loss of control over the breaker.
▶
Check that the side handle is fitted correctly and tightened securely.
▶
Fit the side handle.
5.1.2 Changing the accessory tool 3
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶
Wear protective gloves when changing the tool.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
▶
The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Use only the recommended grease supplied by Hilti . Use of unsuitable grease may cause damage
to the product.
5.1.3 Removing the accessory tool 4
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶
Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶
Wear protective gloves when changing the tool.
▶
Remove the accessory tool.
5.1.4 Positioning the chisel
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶
Do not operate the tool when the selector switch is set to “Chisel positioning”. Turn the function selector
switch until it engages in the “Chiseling” position.
The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶
Fit the accessory tool. → page 17
5.1.5 Setting the chiseling power
1. Press the power level selector switch.
▶
The power level indicator lights yellow.