*2201899*
2201899
English 17
Trouble or fault
Possible cause
Action to be taken
1 LED on the battery
flashes.
Battery is discharged.
▶
Change the battery
and charge the empty
battery.
The battery is too hot or
too cold.
▶
Bring the battery to
the recommended
working temperature.
4 LEDs on the bat-
tery flash.
Product momentarily
overloaded.
▶
Release the control
switch and then press
it again.
Protection against over-
heating.
▶
Allow the product to
cool down and clean
the air vents.
Product does not
develop full power.
The control switch is not
fully pressed.
▶
Press the control
switch as far as it will
go.
The half-power button is
engaged.
▶
Press the "half-power"
button.
Drill bit does not
rotate.
The function selector
switch is not engaged or
is in the "Chiseling" po-
sition
or the "Chisel
positioning" position
.
▶
With the motor at
a standstill, set the
function selector
switch to the "Hammer
drilling"
position.
The insert tool can-
not be released from
the chuck.
The chuck is not pulled
back fully.
▶
Pull the chuck back
as far as it will go and
remove the accessory
tool.
The side handle is not
fitted correctly.
▶
Disengage the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
Product does not
start.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
▶
Switch the product off
and then on again.
The service indicator
lights.
Service limit time
reached.
▶
Have the product
repaired by
Hilti
Service.
Summary of Contents for TE 60-A36
