![background image](http://html1.mh-extra.com/html/hilti/te-6-s/te-6-s_operating-instructions-manual_2135435015.webp)
10
11. Disposal
Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back
your old electric tools for recycling. Please ask your Hilti customer service department or Hilti sales representative
for further information.
12. Troubleshooting
Fault
Possible cause
Remedy
The tool doesn’t start.
No power from the mains supply. Plug in another electric tool or
appliance and check whether it works.
Supply cord or plug is defective.
Have it checked by an electrical
specialist and replaced if necessary.
The control switch is defective.
Have it checked by an elecrical
specialist and replaced if necessary.
No hammering action.
The tool is too cold.
Allow the tool to warm up to the
operating temperature
(see section “Operation”).
Function selection switch set to
Set the function selection switch
rotary drilling only.
to hammer drilling.
The tool doesn’t achieve
The cross-section of the
Use an extension cord with
full performance.
extension cord is inadequate.
adequate conductor cross-section
(see section “Operation”).
The control switch is not pressed Press the control switch as far as
as far as it will go.
it will go.
The function selection switch is
Set the function selection switch
set to reduced hamering action.
to hammer drilling.
The reversing switch is set to
Set the reversing switch to
counter-clockwise rotation.
clockwise rotation.
The drill bit can’t be released.
The chuck is not pulled back fully. Pull the chuck back as far as it will go
and remove the insert tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071103 / 000 / 00