![background image](http://html1.mh-extra.com/html/hilti/te-3000-avr/te-3000-avr_original-operating-instructions_2135984022.webp)
16
English
5.2 Types of work
WARNING
Risk of electric shock!
Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶
Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶
Do not use the product unless these safety measures are in place and fully operational.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Personal protective equipment
The user and any other persons in the vicinity must wear suitable eye protection, a hard hat, ear protection,
protective gloves, safety footwear and respiratory protection while the tool is in use.
5.2.2 Chiseling
1. Plug the supply cord into the power outlet.
2. Bring the chisel into contact with the workpiece about 80 -100 mm (3¹⁄₈" - 4") from its edge.
3. Press the on / off switch fully.
4. Begin with the chisel positioned at an angle of 70° to 80° to the concrete surface, with the tip of the chisel
pointing toward the edge of the workpiece. Break material away by subsequently increasing the angle to
approx. 90° as the chisel penetrates.
◁
When working close to reinforcing bars, always guide the tip of the chisel toward the edge of the
workpiece, not toward a reinforcing bar.
Note
Working at low temperatures:
The hammering mechanism works only when the power tool has reached a minimum operating
temperature. Bring the chisel into contact with the workpiece and allow the power tool to run
under no load until the required temperature is reached. If necessary, repeat this procedure until
the hammering mechanism begins to operate.
6 Care and maintenance
WARNING
Danger of electric shock!
Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶
Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Printed: 11.06.2018 | Doc-Nr: PUB / 5330316 / 000 / 00
Summary of Contents for TE 3000-AVR
