Hilti SIW 22T-A 0.5 Inch, Manual

Page: 15 / 20

English 13
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The tool doesn’t work. The battery is not fitted correctly.
▶
The battery must be heard to
engage. Remove the battery
and refit it.
The tool doesn’t work – 1
LED blinks.
1 LED blinks: The battery is empty.
▶
Remove the battery and charge
it.
The battery is too hot or too cold.
▶
Allow the battery to cool down
/ warm up to its working
temperature.
The tool doesn’t work – 4
LEDs blink.
The power tool was overloaded
briefly.
▶
Release the control switch and
then press it again.
The control switch cannot be
pressed.
The forward / reverse selector
switch is in the middle position.
▶
Push the forward / reverse
switch to the left or right.
Speed of rotation drops con-
siderably.
Low battery.
▶
Remove the battery and charge
it.
The battery is not heard to
engage.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs.
The battery runs low more
quickly than usual.
Very low ambient temperature.
▶
Warm up the battery slowly to
room temperature.
The tool or the battery gets
very hot.
The tool is overloaded (application
limits exceeded).
▶
Intense heat is produced.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store , or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
Printed: 05.04.2018 | Doc-Nr: PUB / 5136064 / 000 / 05