Symbols
Read the
operating
instructions
before use.
Location of identification data on the appliance
The type designation and the serial number are stamped
on the rear of the appliance. Make a note of this data in
your operating instructions and always refer to it when
making an enquiry to your Hilti representative or service
department.
2 Description
2.1 Use of the product as directed
The stand-up decking fastening tool is an accessory
for use with Hilti metal construction screwdrivers. The
unit (screwdriver and stand-up tool) is used to drive
the recommended metal construction screws (collated
self-drilling screws) in sheet metal. The stand-up tool is
designed to be used to fasten metal sheets by driving
screws downwards into steel supports. The total thick-
ness of the items through which the screws are driven
(metal sheets and steel support) must not exceed 15 mm.
The working environment may be a construction site of
any kind where metal construction work is taking place.
Use only the specified accessory items.
The general safety instructions listed in the operating
instructions must be observed.
2.2 The items supplied include:
1 SDT 5 stand-up fastening tool for decking
1 Bit (system socket)
1 Operating instructions
1 Cardboard box
3 Accessories
SDT 5
Designation
Magazine guide
Bag for screw strips
4 Technical data
Right of technical changes reserved.
The appliance
SDT 5
Weight of the appliance without screwdriver and
screws
3.9 kg
Hilti metal constr. screwdriver chuck type
¹⁄₄"Hex. socket
Chuck / bit or socket
¹⁄₄"Hexagon
Height adjustment
76…118 cm
Forward / reverse
X
Screw capacity
Max. 50
en
7
Summary of Contents for SDT 5
Page 2: ...ꙣ Ꙥ ꙥ Ꙧ ꙧ Ꙩ ꙩ Ꙫ ꙫ Ꙭ 1 ...
Page 3: ...4 2 2 3 3 3 3 1 1 4 4 2 3 5 1 2 4 6 3 4 2 3 1 5 ...
Page 4: ...1 2 3 6 7 1 3 2 8 9 2 2 1 10 ...
Page 5: ...4 2 3 4 1 11 ...