8
4. Refit the depth gauge after removing the screws.
6.3 Switching on in sustained operating mode
8
▶
Switch on in sustained operating mode.
6.4 Switching off after sustained operation
▶
Press the control switch.
◁
The lockbutton returns to its original position.
6.5 Screwdriver / depth gauge interface
9
Note
With the drive spindle exposed in this way, the following operations can be carried out:
Removing screws (set to reverse rotation),
changing bits,
changing bit holders,
changing to magazine mode with the SMD 57 magazine,
redriving screws.
▶
Pull the depth gauge away from the power tool, releasing the snap-on connection.
7 Care and maintenance
7.1 Care of the product
WARNING
Electrical hazards!
Improper repairs to electrical parts may lead to serious injuries.
▶
Electrical parts may be repaired only by trained electrical specialists.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local
Hilti
Center or online at:
www.hilti.com
▶
Keep the screwdriver, especially its grip surfaces, clean and free from oil and grease. Do not use cleaning
agents containing silicone.
▶
Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not permit foreign objects to enter the interior of the screwdriver.
▶
Clean the outer surfaces of the power tool with a damp cloth at regular intervals.
▶
Do not use a spray, pressure jet washer or running water for cleaning. This may negatively affect the
electrical safety of the screwdriver.
8 Troubleshooting
Note
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem
by yourself, please contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The screwdriver doesn’t
work.
Low battery.
▶
Use an approved charger to
charge the battery. → page 6
The battery is not in the working
position.
▶
Insert the battery. → page 6
The screwdriver doesn’t work
and one LED blinks.
Low battery.
▶
Change or charge the battery.
Printed: 26.10.2015 | Doc-Nr: PUB / 5070549 / 000 / 03
