Hilti NURON SSH 6-22, Manual

Page: 14 / 64

8 English 2331869
*2331869*
4.1 Battery
Battery operating voltage 21.6 V
Weight, battery See the end of these operating
instructions
Ambient temperature for operation −17 ℃ … 60 ℃
(1 ℉ … 140 ℉)
Storage temperature
−20 ℃ … 40 ℃
(−4 ℉ … 104 ℉)
Battery charging starting temperature −10 ℃ … 45 ℃
(14 ℉ … 113 ℉)
4.2 Blade
Blades of different types are needed, depending on the thickness or strength of the material to be cut. Select
the correct blade for the purpose from the table below.
The blades have two cutting edges. The cutting edges cannot be resharpened.
Initial equipment, as supplied ex works: SSH­CS 1.5 ­ 2.5 mm or SSH­CD4 mm × 0.9 mm
SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
SSH­CS,
1.5 ­ 2.5 mm,
, for
straight cuts
SSH­CX,
0.5 ­ 1.5 mm,
, for
straight cuts
in stainless
steel
SSH­CC,
0.5 ­ 1.5 mm,
, for curves
SSH­CD,
4 x 0.9 mm,
, for spiral
ducting
Permissible steel
thickness, steel
up to 400 N⁄mm²
1.5 mm
(0.06 in) 16 ga
2.5 mm
(0.10 in) 13 ga
•/• 1.5 mm
(0.06 in) 16 ga
•/•
Permissible steel
thickness, steel
up to 600 N⁄mm²
1.0 mm
(0.04 in) 20 ga
•/• 1.5 mm
(0.06 in) 16 ga
0.8 mm
(0.03 in) 22 ga
•/•
Permissible ma-
terial thickness,
aluminum up to
250 N⁄mm²
2.0 mm
(0.08 in) 12 ga
3.0 mm
(0.12 in) 9 ga
•/• 2.0 mm
(0.08 in) 12 ga
•/•
Permissible
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
•/• •/• •/• •/• 4 x 0.9 mm
(4 x 0.035 in)
4 x 20 ga
Permissible
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
•/• •/• •/• •/• 4 x 0.6 mm
(4 x 0.024 in)
4 x 24 ga
Starting hole di-
ameter
17 mm
(0.7 in)
22 mm
(0.9 in)
20 mm
(0.8 in)
15 mm
(0.6 in)
18 mm
(0.7 in)
Smallest radius
for curved cut-
outs
80 mm
(3.1 in)
150 mm
(5.9 in)
120 mm
(4.7 in)
L 45 mm (2 in),
R 80 mm
(3.15 in)
150 mm
(5.9 in)