Hilti NURON SC 4WL-22, Original Operating Instructions

Page: 35 / 508

*2276127*
2276127 English 29
5.9 Installing fence 6
1. Back off the clamping screw until you can insert the fence.
2. Push the fence into the base plate.
▶
You can adjust the cutting width to suit your application.
3. Tighten the clamping screw.
5.10 Installing guide rail adapter 7
The guide rail adapter is available as an accessory.
1. Remove the fence, if fitted.
2. Hook the base plate into the rear retaining lugs of the guide rail adapter.
3. Set the base plate down on the guide rail adapter.
▶
The base plate is flush on the guide rail adapter.
4. Lock the guide rail adapter by pressing in the two sliders as far as they will go.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on or off
Switching on
1. Press and hold down the switch-on interlock and press the on/off button.
▶
You can release the switch-on interlock as soon as you have the on/off switch held down.
Switching off
2. Release the on/off switch.
▶
The switch-on interlock jumps automatically into the locked position.
6.2 Sawing along a line 8
Saw only flat workpieces that offer a big enough contact surface to accommodate the whole of the
base plate.
1. Position the workpiece so that the saw blade is free to rotate beneath it.
2. Secure the workpiece to prevent movement.
3. Bring the front edge of the base plate into contact with the workpiece.
▶
Saw blade clear of the workpiece.
4. Switch the product on. → page 29
5. Guide the saw along the cutting line at a suitable speed for it to cut smoothly through the workpiece.
6.3 Longitudinal cuts at 0° 9
Use the guide rail adapter for a saw with a small base plate.
1. Secure the guide rail with 2 screw clamps.
2. Set the saw on the guide rail with the 0° groove mark on the rib of the guide rail.
3. Switch the product on. → page 29
4. Advance the saw along the guide rail to make the cut through the workpiece.
6.4 Longitudinal cuts at angles up to 50° 10
Use the guide rail adapter for a saw with a small base plate.