Hilti NURON GTB 6X-22, Manual

Page: 25 / 288

*2327538*
2327538 English 19
3 Description
3.1 Product overview 1
@
Guide roller
;
Lockable on/off switch
=
Adjusting knob for speed
%
Battery status indicator
&
Battery release button
(
Battery
)
Dust filter
+
Hand guard
§
Drive roller
/
Spindle lock button
:
Working range
∙
Relay roller
$
Abrasive belt
£
Swing arm
|
Side handle
3.2 Intended use
The product described is a hand-held, cordless pipe belt grinder. It is designed for grinding and polishing
metal pipes and round-section bar stock, without use of water.
• For this product, use only
Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Possible misuse
Do not use the product for wet grinding.
Do not use the product to work on hazardous or flammable materials (e.g. asbestos, magnesium, wood).
3.4 Items supplied
Pipe belt grinder, side handle, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.5 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the product’s performance
drops noticeably or it might stall completely.
If the product stalls or slows significantly due to overloading, relieve the pressure applied to the product and
then allow it to run under no load for approx. 30 seconds.
3.6 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.