![background image](http://html1.mh-extra.com/html/hilti/nct-is-045-a22/nct-is-045-a22_manual_2135076013.webp)
*2258525*
2258525
English
9
8
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport
!
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit.
Comply with the locally applicable
regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶
Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries
!
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
9.1
The cutting tool is not in working order
Malfunction
Possible cause
Action to be taken
No response from the LEDs
on the battery.
The battery is not fully inserted.
▶
Push the battery in until it
engages with a double click.
Battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool
down or to warm up to room
temperature.
1 LED on the battery flashes.
Battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool
down or to warm up to room
temperature.
4 LEDs on the battery flash.
Product momentarily overloaded.
▶
Allow the product to cool down.
Red LED => lights continu-
ously and a warning tone is
emitted.
Technical problem.
▶
Incorrect operation is possible!
Contact
Hilti
Service.
Red LED => flashes at short
intervals and a warning tone
is emitted.
The state of charge of the battery
is too low to allow a complete op-
erating cycle.
▶
Change the battery and charge
the empty battery.