Hilti HIT-HY 200-A
28
Adhesive anchoring system for rebar and anchor fastenings in concrete.
Hilti HIT-HY 200-A
Contains:
Hydroxypropylmethacrylat (A), 1,4-Butandiol-dimethacrylat (A), Dibenzoylperoxid (B)
(A, B)
(B)
Warning
H317 May cause an allergic skin reaction. (A, B)
H319 Causes serious eye irritation. (B)
H410 Very toxic to aquatic life with long lasting effects. (B)
P262 Do not get in eyes, on skin or on clothing.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P302 + P352 IF ON SKIN: Wash with plenty of soap and water.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
P333+313 If skin irritation or rash occurs: Get medical advice/attention.
P337+313 If eye irritation persists: Get medical advice/attention.
Disposal considerations
Empty packs:
▶ Leave the mixer attached and dispose of via the local Green Dot recovery system
▶ or EAK waste material code: 150102 plastic packaging
Full or partially emptied packs:
▶ Must be disposed of as special waste in accordance with official regulations.
– EAK waste material code: 08 04 09* waste adhesives and sealants containing organic solvents or other
dangerous substances.
– or EAK waste material code: 20 01 27* paint, inks, adhesives and resins containing dangerous
substances.
Content
: 330 ml / 11.1 fl.oz. 500 ml / 16.9 fl. oz
Weight
: 590 g / 20.8 oz
890 g / 31.4 oz
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions.
– Failure to observe the instructions for use and setting data, incorrect use
– Inadequate design of the anchor points, inadequate load bearing capacity of the base material
– Other influences of which Hilti is not aware or on which Hilti has no influence,
e.g. use with products from a third party.