![background image](http://html.mh-extra.com/html/hilti/gdg-6-a22/gdg-6-a22_original-instructions-manual_2135650027.webp)
*2276758*
2276758
English
23
4. Position the new clamping nut with collet on the spindle, engage the threads and loosely screw the
clamping nut on to the spindle. Do not tighten the clamping nut.
8
Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport
!
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check accessory tools and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries
!
▶
Always store your products with the batteries removed!
▶
Store the tool, accessory tools and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool, accessory tools and batteries in a place where they cannot be accessed by children or
unauthorized persons.
▶
Check the tool, accessory tools and batteries for damage before use after long periods of storage.
9
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Allow the battery to warm up
slowly to room temperature.
The battery doesn’t engage
with an audible click.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and refit
the battery.
1 LED flashes.
The device does not work.
Low battery.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool down
or warm up slowly to room
temperature.
All 4 LEDs flash.
The device does not work.
The tool has been overloaded.
▶
Switch the power tool off and
then on again. Then allow the
power tool to run under no load
for approx. 30 seconds.
The power tool or battery
gets very hot.
Electrical fault
▶
Switch the power tool off im-
mediately, remove the battery,
keep it under observation, allow
it to cool down and contact
Hilti
Service.
The power tool does not de-
velop full power.
A battery with inadequate capacity
was used.
▶
Use a battery with adequate
capacity.
The motor has no braking
effect.
Low battery.
▶
Change the battery and charge
the empty battery.
The power tool was overloaded
briefly.
▶
Switch the power tool off and
then on again.
The power tool vibrates
strongly.
Accessory tool is not compatible
with the power tool.
▶
Use only accessory tools that
comply with the specifications
in the technical data.
Summary of Contents for GDG 6--A22
