*2235115*
2235115
English
5
1.5 Product information
products are designed for professional users and only trained, authorized
personnel are permitted to operate, service and maintain the products. This personnel
must be specifically informed about the possible hazards. The product and its ancillary
equipment can present hazards if used incorrectly by untrained personnel or if used not
in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶
Write down the serial number in the table below. You will be required to state the
product details when contacting Hilti Service or your local Hilti organization to inquire
about the product.
Product information
Wire saw
DSW 2005-TS
Generation
01
Serial no.
2
Safety
2.1 General safety instructions
Study all safety instructions and other instructions, images and technical data with
which this product is provided.
Failure to comply with the instructions below can cause
serious injuries.
Keep all safety precautions and instructions for future reference.
2.2 Proper arrangement of the workplace
▶
Approval must be obtained from the site engineer or site management before beginning
drilling and sawing work. Drilling and sawing work on buildings and other structures
can influence the statics, especially when steel reinforcing bars and load-bearing
components are cut through.
▶
Ensure that good lighting is in use.
▶
Ensure that the workplace is well ventilated. Poorly ventilated workplaces can result
in damage to health because of exposure to dust.
▶
Keep the workplace tidy. Objects which could cause injury should be removed from
the working area. Untidiness at the workplace can lead to accidents.
▶
In order to avoid injuries and to prevent the diamond wire becoming trapped and
stuck, steel wedges and/or supports must be used to prevent uncontrolled movement
of objects that are being cut free.
▶
Ensure that adequately-sized supports are correctly installed so that the remaining
structure maintains its stability after completion of the cutting work and removal of the
part cut away.
▶
Never loiter in areas where loads are suspended by crane or lifting equipment.
▶
The area of the cut or the opening created by the cutting process must be safely and
visibly cordoned off in order to avoid the risk of persons falling.
▶
Wear personal protective equipment. Wear safety footwear, protective gloves, a hard
hat and protective glasses.
▶
Wear respiratory protection if the work causes dust.
▶
Wear suitable work clothes. Do not wear jewelry or loose clothing that could be
snagged by moving parts. If your hair is long, wear a hair net.
▶
Do not allow other persons to touch the equipment or the extension cord.
Summary of Contents for DSW 2005-TS
