Hilti BX 3-ME, Original Operating Instructions, Page: 27 / 438

English 21
When battery performance drops, it takes longer (than with a fully charged battery) until the fastening tool is
ready to drive the next fastener.
If you continue to operate the fastening tool after battery performance drops, the fastening tool will switch
itself off automatically before damage to the battery occurs.
3.9 Items supplied
BX 3-ME fastening tool, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4 Technical data
4.1 Fastening tool
Weight in accordance with EPTA procedure
01/2003
B 22/2.6 Li­Ion (02) 3.8 kg
B 22/3.0 Li­Ion (01)
3.9 kg
B 22/5.2 Li-Ion (01) 4.1 kg
Nail length (collated nails) 14 mm …24 mm
Nail length (single nails)
30 mm …36 mm
Nail diameter 3.0 mm
Magazine capacity 20 nails
Compression stroke 12 mm
Contact pressure 50 N …70 N
Application temperature (ambient temperature) −15 ℃ …50 ℃
Recommended maximum fastening rate 650/h
Rated voltage
21.6 V
Frequency 2,400 MHz …2,483.5 MHz
Maximum emitted transmission power −11.9 dBm
4.2 Noise information and vibration values
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one power tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the power
tool. However, if the power tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the total
working period. Set out additional safety measures to protect the operator from the effects of noise and/or
vibration, such as: Maintaining the power tool and accessories, keeping the hands warm, reorganization of
work patterns.
Noise and vibration information (measured in accordance with EN 60745-2­16)
Typical A­rated emission sound pressure level, L
WA
(when driving nails
into concrete and steel)
100 dB
Typical A­rated emission sound pressure level, L
pA
(when driving nails
into concrete and steel)
89 dB
Uncertainty for the specified sound levels, K 3 dB
Total uniaxial vibration values (in z-direction)
Vibration emission value, a
h
(when driving nails into concrete and
steel)
2.5 m/s²
Uncertainty, K 1.5 m/s²
Printed: 04.10.2017 | Doc-Nr: PUB / 5377483 / 000 / 01