hilscher netHOST NHST-T100, User Manua

Page: 36 / 75

Device drawings and connectors 36/75
5.7.3 DeviceNet interface (NHST-T100-DN/DNM)
The pin assignment of the DeviceNet interface at X3 complies with the
DeviceNet standard.
DeviceNet Pin Signal Description
COMBICON
socket, female
1 ISO GND Common ground
DeviceNet-power supply.
2 CAN L CAN Low signal
3 Drain Shield
4 CAN H CAN High signal
5 V+ +24 V DeviceNet-power supply
Table 27: DeviceNet pin assignment
5.8 USB interface (Mini-B USB)
For identification, see section Positions of the LEDs, connectors and control
elements [
}
page 31].
The USB interface can be used to perform a firmware download/firmware
recovery to the netHOST device to its “factory settings” (see section
Using
USB to recover firmware [
}
page 47]).
USB Buchse Pin Signal Description
1 USB_EXT Power supply USB Bus (+5 V, from externally)
2 D- Data -
3 D+ Data +
4 ID
5 GND Ground
Shield PE Metal shell to PE
Table 28: Pin assignment Mini-B USB connector (5-pin)
5.9 Schematic diagram of Galvanic isolation
The following schematic diagram illustrates the internal connections
between the different connectors X1, X2 and X3 of the netHOST device.
This gives you the chance to properly install the device in accordance with
the “potential equalization concept” of your plant.
Note:
The PE connection (potential equalization) of the device is done via
the DIN rail.
netHOST NHST-T100 | LAN controlled master devices
DOC130401UM05EN | Revision 5 | English | 2018-05 | Released | Public © Hilscher 2013 – 2018