Diagnosis with LEDs
30/63
5.6
PROFINET IO-Device
For the
protocol, the communication LEDs
SF
(system
failure) and
BF
(bus failure) as well as the Ethernet LEDs
LINK
and
RX/TX
can assume the states described below. This description is valid from stack
version V3.x (V3).
Communication status PROFINET IO-Device
LED
Color
State
Description
SF
(System Failure)
Position in the device
overview:
(10)
Duo LED red/green
(off)
Off
No error
(red)
Flashing
(1 Hz, 3 s)
signal service is initiated via the bus.
(red)
On
Watchdog timeout; channel, generic or extended diagnosis
present; system error
BF
(Bus Failure)
Position in the device
overview:
(7)
Duo LED red/green
(off)
Off
No error
(red)
Flashing
(2 Hz)
No data exchange
(red)
On
No configuration;
or low speed physical link; or no physical link
Table 30: Communication status PROFINET IO-Device
LED state
Definition
Flashing
(1 Hz, 3 s)
The LED turns on and off for 3 seconds with a frequency of 1 Hz: “On” for
500 ms, followed by “Off” for 500 ms.
Flashing
(2 Hz)
The LED turns on and off with a frequency of
2 Hz: “On” for 250 ms, followed by “Off” for 250 ms.
Table 31: Definition LED states communication status
Ethernet status PROFINET IO-Device
LED
Color
State
Description
LINK
Ch0:
(11)
, Ch1:
(8)
LED green
(green)
On
The device is linked to the Ethernet.
(off)
Off
The device has no link to the Ethernet.
RX/TX
Ch0:
(9)
, Ch1:
(6)
LED yellow
(yellow)
Flickering
(load
dependent)
The device sends/receives Ethernet frames.
(off)
Off
The device does not send/receive Ethernet frames.
Table 32: Ethernet status PROFINET IO-Device
LED state
Definition
Flickering
(load
dependent)
The LED turns on and off with a frequency of approximately 10 Hz to
indicate high Ethernet activity: "On" for approximately 50 ms, followed by
"Off" for 50 ms. The LED turns on and off in irregular intervals to indicate low
Ethernet activity.
Table 33: Definition LED states Ethernet status
CIFX M223090AE-RE\F | Hardware description and installation
DOC190704UM06EN | Revision 6 | English | 2022-02 | Released | Public
© Hilscher 2019 - 2022
