hilscher CIFX M223090AE-RE/F, User Manual

Page: 19 / 63

Installing the hardware 19/63
4.4 Installing the hardware
Install the PC card CIFX M223090AE-RE\F in your PC or connection
device as described below.
1. Preparation
Note the requirements and prerequisites described in the sections System
Requirements [
}
page 15] and Requirements for operation [
}
page 17].
2. Protective measures and safety precautions
Hazardous voltage! Danger to life, risk of injury by
electric shock
Ø Disconnect the power plug of the PC (or connection device).
Ø
Make sure that the power supply is off at the PC (or connection device).
Personal injury, device damage due to hot-plug/hot-swap
Ø
Do not "plug" or "unplug" the PC card during operation.
Adhere to the necessary safety precautions for
components that are vulnerable with electrostatic discharge.
Ø
Make sure that the device is grounded via the endplate and the PC, and
make sure that you are discharged when you install/uninstall the device.
Device damage due to over torquing of the mounting
screw
Ø
Do not over torque the screw used to mount the basic card to the board
to prevent damage to the printed circuit board.
3. Installation
Ø
Open the housing of the PC or connection device.
Ø
Insert the basic card into the PCI Express M.2 slot.
Ø
Screw the basic card onto the board. To do this, use the crescent-
shaped hole on the top edge of the basic card. The ground contact via
the screw head must be ensured.
Ø
First, attach the detached network interface Ethernet AIFX-V2-RE to the
housing panel of the PC or connection device.
Ø Then connect the detached network interface Ethernet AIFX-V2-RE to
the basic card.
Important:
Note that the detached network interface Ethernet AIFX-V2-RE
especially is designed for netX 90-based devices and exclusively
works together with them.
In contrast, the detached network interface Ethernet AIFX-RE is
only suitable for netX 100-based devices.
Ø
For this purpose, first plug the cable into the Ethernet X1 cable
connector on the AIFX-V2-RE.
CIFX M223090AE-RE\F | Hardware description and installation
DOC190704UM06EN | Revision 6 | English | 2022-02 | Released | Public © Hilscher 2019 - 2022