hilscher CIFX M223090AE-RE/F, User Manual

Page: 17 / 63

Installing the hardware 17/63
4.2 Requirements for operation
The following described requirements must be fulfilled when operating the
PC card.
Requirements Specification Refer to section
Hardware installation Operating the PC card CIFX M223090AE-RE\F requires
proper connection of the detached network interface Ethernet
AIFX-V2-RE to the basic card. -
Communication
For the communication of a PC card (Slave), a Master device
is required for the communication system used.
To configure the Master device you need the device
description file with the name for:
· EtherCAT Slave:
Hilscher CIFX RE NETX90 ECS.xml
,
·
EtherNet/IP Adapter:
HILSCHER CIFX-RE NETX90 EIS V1.1.EDS
,
· and PROFINET IO-Device:
GSDML-V2.35-HILSCHER-CIFX NETX 90 RE
PNS-20200402.xml
.
The settings in the used Master must match the settings in
the Slave.
-
Software installation cifX Device Driver as driver for the host interface (latest
version of the driver).
Device Explorer as software for downloading or updating the
firmware and configuration, as well as for setting the device
driver.
Communication Studio for configuration and diagnosis of
netX 90-based devices.
Revision or version status
of hardware and
software
[ } page 8] and
References [
}
page 49]
(Documentation on drivers
and software)
Firmware download The user must select the firmware using the Device Explorer
software and download it to the PC card.
The firmware includes a communication protocol.
Parameter settings By use of the Communication Studio configuration software
the PC card must be parameterized.
Table 11: Requirements for operation
CIFX M223090AE-RE\F | Hardware description and installation
DOC190704UM06EN | Revision 6 | English | 2022-02 | Released | Public © Hilscher 2019 - 2022