301 Chestnut Street, East Longmeadow, MA 01028 + 1-800-628-8810
8
Track Mode:
To Select Track Mode
1. The hilmor Digital Adjustable Torque Wrench will be set from the factory to
Peak Mode. This can be verified by looking for the small “P” in the bottom
right corner of the screen.
2. To change to Track Mode, first press and hold
until
appears.
3. Press the
or
arrows to select T (Track Mode) or P (Peak Mode).
4. Press
again.
5. Press
repeatedly until the display screen is showing the torque reading.
Check for a P or T in the bottom right corner.
Usage Instructions (Track Mode):
1. Apply force slowly at the center of the handle.
2. As the flare nut is tightened, the actual torque value will appear on the screen
and increase as more torque is applied.
3. LED lights along the sides of the display will increase as the hilmor Digital
Adjustable Torque Wrench gets closer to the desired torque value. A buzzer
will sound as torque is applied, speeding up as torque is increased.
4. When the desired torque value is reached, the value will appear on the
display, the green lights will continue and a red light will appear. The buzzer
will also change to a steady tone.
• Do not torque to more than 110% of maximum torque range. This
will cause an error message
to appear and can decrease
the accuracy of the hilmor Digital Adjustable Torque Wrench and
require recalibration.
• Maximum torque values: 135 N-m, 99.5 ft-lbs, 1195 in-lbs, 1378 kg-cm.