Hillyard TRIDENT T26SC PLUS, Service Manual

Page: 25 / 62

4.3.6 Vacuum Cover
• Put the machine in safe conditions.
• Tilt the recovery tank.
• Unscrew the pivot covering cap
(see fig.
4.3.6-17 )
.
• Extract the pin with the help of a pli-
ers
(see fig. 4.3.6-18 )
.
• Proceed at reverse to refit the part.
4.3.6-17 4.3.6-18
4.3.7 Vacuum Motor
• Put the machine in safe conditions.
• Tilt the Recovery Tank.
• Disconnect the power cables of the
Vacuum Motor.
• Remove the screws and remove the
Vacuum Motor carter and the con-
densate drain pipe
(see fig. 4.3.7-19 )
.
• Unscrew the nuts that fix the suc-
tion motor to the recovery tank
(see fig.
4.3.7-20 )
.
• Remove the suction motor and re-
move the sound absorbing sponge.
• Unscrew the screws to remove the
motor fixing plate and remove the
cap
(see fig. 4.3.7-21 )
.
• Proceed at reverse to refit the part.
4.3.7-19 4.3.7-20
4.3.7-21
4.4 Frame and Traction
System
4.4.1 Wheels
• Put the machine in safe conditions.
• Lift up the wheel from the ground.
• Remove the cap and loose the screw
that blocks the wheel to the Drive
Shaft
(see fig. 4.4.1-22 )
.
• Remove the wheel pulling it by
hands or using a extractor.
• Remove the spacer.
• Proceed at reverse to refit the part
(Use the thread lock liquid on the
screw during the assembling).
4.4.1-22
25