Hillyard TRIDENT NM14, Service Manual

Page: 18 / 39

4.1 Electrical Installation
•
Put the machine in safe conditions.
• Open the front Carter and remove
both tanks
(see fig. 4.1.0-3 )
.
•
Turn the handlebar forward in hori-
zontal position and put the machine
vertically
(see fig. 4.1.0-4 )
.
•
Using the screwdriver PH1x200 re-
move the screws that secure the rear
cover to the frame and remove the
rear cover, paying attention to the
rear wheels
(see fig. 4.1.0-5 )
.
• Disconnect the connectors from the
Main Card
, remove the screws and
remove the card
(see fig. 4.1.0-6 )
.
•
Unscrew the screws holding the On
/ Off button at the rear cover and
remove it paying attention to the
spring.
• Disconnect the cables from the main
switch and release it from the seat
acting on the side mounting tabs
(see
fig. 4.1.0-7 )
.
• Do the same with the water switch .
•
Loosen the screws holding the cover
plate of the park microswitch, and
remove the plate.
•
Disconnect the cables of the
park
microswitch and remove it from the
seat
(see fig. 4.1.0-8 )
.
•
Remove the hoses cover by unscrew-
ing the fixing screws.
• Disconnect the connectors of the
LED light
, free the wiring and re-
move the light from the LED seat
(see
fig. 4.1.0-9 )
.
4.1.0-3 4.1.0-4
4.1.0-5 4.1.0-6
4.1.0-7 4.1.0-8
4.1.0-9
18