Hills Rotary 400, Installer Manual

Page: 9 / 16

9
Item 6: Repairing the Handle Assembly
1. To remove the Handle Assembly, the Shroud Plug and Badge need to be removed.
2. The Badge will disengage from the Handle Assembly by gently levering using a small
screwdriver (Fig. 24).
3. Remove the Shroud Plug by punching a hole in the centre, then lever out the retaining
snaps. This prevents damaging the Handle Shroud (Fig. 25).
4. Remove the two screws and pull the Handle Assembly away from the standard
(Fig. 26 and 27).
5. Ensure the Handle Spring does not fall out of the Handle Assembly when removing
the assembly. (Fig. 28).
6. To replace the Handle use a pair of pliers to disengage the snaps at the back of the
Handle Shroud (Fig. 29).
7. To reassemble the Handle snap it back into the Handle Bush with the Handle Shroud
and Spacer Ring in between (Fig. 30).
8. Re-attach the assembly to the standard with the two fasteners, replace the Badge and
snap in a New Shroud Plug (Fig. 31 and 32).
Fig. 24 Fig. 25 Fig. 26
Fig. 27 Fig. 28 Fig. 29
Fig. 30 Fig. 31 Fig. 32