Hill-Rom CarePorter P3000, Service Manual

Page: 47 / 220

2.2 Powered Equipment Shelf
Chapter 2: Troubleshooting Procedures
Page 2 - 10 CarePorter™ Cart Service Manual (man239)
2.2 Powered Equipment Shelf
1. Ensure the CarePorter™ Cart is plugged into an appropriate power source.
WARNING:
Ensure the CarePorter™ Cart is not attached to a bed or stretcher
during this procedure. Possible personal injury or equipment damage
could occur.
2. Disengage the CarePorter™ Cart from the bed or stretcher.
3. Another part of the CarePorter™ Cart interferes with the powered
equipment shelf.
Yes No
↓ →
Go to step 6.
4. Take appropriate actions to eliminate the interference.
This solves the problem.
Yes No
↓ →
Go to step 6.
5. Go to “Final Actions” on page 2-5.
6. Check the P.C. board to see if voltage is present. Voltage is present on the
P.C. board.
Yes No
↓ →
Check for power in the wall outlet, and from the TPM. If
necessary, find a wall outlet with the appropriate power source.
If this solves the problem, go to “Final Actions” on page 2-5.
Otherwise, go to step 7.
7. Check for continuity of the up/down shelf cable. If necessary, replace the
up/down shelf cable.
This solves the problem.
Yes No
↓ →
Go to step 9.
8. Go to “Final Actions” on page 2-5.
9. Momentarily activate powered equipment shelf rocker switch. The motor
runs.