28
27
33
31
26
32
30
25
29
PAGE 6
AUX Input for CHANNEL1. This is a 3.5mm Mini-TRS stereo socket which allows to connect
sources like MP3 players etc. without removing the mixer from its mounting position. Once a
plug is inserted, the rear panel inputs for CHANNEL1 are disabled and the connected source
is active.
Level control of input channels. Allows adjustment of the respective channel level.
PFL switch for input channels. Assigns the respective channel to the headphone bus for
pre-fader-listening (PFL) by means of the headphone output (37). A LED indicates the pressed
position.
Signal/Peak LED. This LED will illuminate when an input signal with more than -30dB of signal
level is present, and will turn to red once the input signal reaches 0dB. This facilitates to see
which channels have a signal present, without using the CUE function. It further helps to set
the rear-panel gain controls (17) correctly for proper gain balance.
FOH level control. Allows adjustment of the volume of the balanced stereo FOH input (15).
Main (stereo) output level control. Determines the main output level present at outputs
(2)/(3)/(4).
Equalizer for Main (Stereo) output. This is a 2-band stereo equalizer to adjust the frequency
response of the output.
Main (Stereo) output level meter. Displays the output level of the stereo main output
(2)/(3)/(4). Note that the level limitation applied by means of the rear-side maximum level
control (5) is not displayed on this meter.
Zone (Mono) output level control. Determines the main output level present at outputs (7)/(8).
Zone source selection switch. This rotary switch allows to either use the master mix bus
[same signal as carried by the stereo master output (2)/(3)/(4)] or any of the individual,
assigned source signals to the Inputs 1/2/3/4/5 (excluding the FOH input), to be used as a
source signal for the Zone (Mono) output.
Zone (Mono) output level meter. Displays the output level of the zone output. Note that the level
limitations applied by means of the rear-side maximum level controls (9) are not displayed on
these meters.
PFL level. Determines the signal volume at the headphone output (37). Always set this control
to minimum before putting on headphones, as sudden high-volume impact may damage your
ears. See further health advice below.
Headphones output. A ¼” TRS connector to connect a headphone. Turn the PFL level (36)
down before plugging in any headphones.
Power switch. Switches the unit on and off. Make sure to switch the unit off when not in use.
USER MANUAL - ZPR2620 2-ZONE MIXER
34
35
36
37
38
Summary of Contents for ZPR-2620
Page 1: ...RevA 06 2013...
