-4-
Connecting the Sensor and Power
wires to your PDC200
Now you need to choose a location to mount
the main unit within the passenger compart-
ment of your vehicle. This position should be
where you can easily see and hear the unit
easily, while not impeding the drivers view.
You can use the adhesive tape included
with the package to mount the unit onto the
chosen location.
Having chosen your location, you should
now route the sensor cable and power wires
from the boot into the front of the vehicle and
towards the main unit.
Plug the sensor cables into the 2 pin
•
connectors, and the power wires into the 4
pin connectors (as shown below).
Operation
When you select reverse gear, you will hear
a beep. This indicates that the PDC200 is
working and has been activated (it does not
necessarily mean that there is something
behind you.)
As you begin to reverse and an object comes
within range, you will hear a beeping sound
from the main unit. The frequency or pitch
depends on the range of the object being
detected. If necessary, you can use the
switch on the side of the unit to increase or
decrease the volume.
The table below shows the alarm speed
corresponding to the range of the object
detected.
Your PDC200 may work slightly differently to
what is shown in the table above depend-
ing on circumstance and also on how your
sensors are positioned. You should practice
using your set up in a known area before us-
ing it in earnest on a day to day basis.
With use, you will find it a convenient and
useful aid to your reverse parking.
