Note:
Press and hold the switch button for 5 seconds to switch the
video output. Four kinds of video outputs are available: TVI,
AHD, CVI, and CVBS.
1.2.3
Overview of Type III Camera
Mounting Base
Tilt Adjusting
Screw
Pan Adjusting Screw
Bubble
Video Cable
Power
Cord
Switch
Button
Safety
Rope
Figure 1-3
Overview of Type III Camera
Note:
Press and hold the switch button for 5 seconds to switch
the video output. Four kinds of video outputs are
available: TVI, AHD, CVI, and CVBS.
2
Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with your
required output to avoid damage.
Make sure the wall is strong enough to withstand three
times the weight of the camera and the bracket.
If the wall is cement, insert expansion screws before
installing the camera. If the wall is wooden, use self-
tapping screw to secure the camera.
If the product does not work properly, contact your
dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1
Installation of Type I Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1.
Disassemble the turret camera by rotating the camera
to align the notch to one of the marks, as shown in the
figure below.