Chapter 8 Event and Alarm
This part introduces the configuration of events. The device takes certain response to triggered
alarm.
8.1 Basic Event
8.1.1 Set Motion Detection
This function detects moving objects in the detection region and trigger linkage actions.
Steps
1. Go to Configuration → Event → Basic Event → Motion Detection .
2. Select the channel No.
3. Check Enable Motion Detection.
4. Optional: Check Enable Motion Detection in PTZ Control, and the device detects moving
targets in PTZ movement.
5. Optional: Highlight moving objects in green.
1) Check Enable Dynamic Analysis for Motion.
2) Go to Configuration → Local to enable Rules.
6. Select Configuration Mode. Normal mode and expert mode are selectable.
-
For the information about normal mode, see Normal Mode .
-
For the information about expert mode, see Expert Mode .
7. Set the arming schedule. See Set Arming Schedule for details.
8. Set linkage methods. See Linkage Method Settings for details.
9. Click Save.
Normal Mode
You can set motion detection parameters according to the device default parameters.
Steps
1. Select normal mode in Configuration.
2. Set the sensitivity of normal mode. The higher the value of sensitivity is, the more sensitive the
motion detection is. If the sensitivity is set to 0, motion detection and dynamic analysis do not
take effect.
3. Click Draw Area. Click and drag the mouse on the live video, then release the mouse to finfish
drawing one area.
Target Capture Camera User Manual
58
Summary of Contents for PanoVu PT Series
Page 1: ...Target Capture Camera User Manual...
Page 103: ...UD20912B...
