Vision Box User Manual
16
You can enter Max in the duration to set continuous outputting.
5)
Click the SendCommand to complete the settings.
Step 2
Select the STROBE_STATUS mode and set the ENABLE_START to start enabling the serial port.
Click the SendCommand to complete the settings
Step 3
Select the STROBE_STATUS mode and set the ENABLE_END to end the serial port enabling.
Click the SendCommand to complete the settings
3.2.4 Configuring Serial Port Property
In the original operating system, the default port used by GPIO is Com2, with the baud rate of
115200, 8 data bits, and 1 stop bit.
Hardware of Vision Box serial port is corresponding to COM port, which can be seen and
configured through “Device Manager”
一
> “Ports (COM & LPT)”. Right click “COM1”, select
“Properties”.
Figure 3-6
Serial port property entrance interface
In “Communications Port (Com1) Properties” interface, select “Resources” page, as shown in
Figure. IRQ information can be found in this window, IRQ corresponded to each COM port is
shown in Table 3-1.
Summary of Contents for MV-VB2100-032G
Page 1: ...Vision Box User Manual UD04763B...
Page 22: ...Vision Box User Manual 21...
