HIKVISION iDS-TCM403-EIR/0411, User Manual, Page: 29 / 87

example, if the trigger distance is 28 m from the approaching direction, the initial position of the
target should be approximately 35 m. The target track should correspond to the actual lane, or the
lane No. cannot be corresponded to when the data is uploaded. Adjust Angle Deviation and
Horizontal Deviation to guarantee the vehicle target is on the corresponding lane. After the debug,
enable Normal Mode to enter the normal working status.
3.2 Set Radar Calibration
Calibrate radar after the radar detection parameters are set to display the targets detected by the
radar on the video.
Before You Start
Enable Rules Information in Configuration → Local .
Steps
1. Click Radar.
2. Click Coordinate Calibration or GPS Calibration.
3. Set the radar calibration.
-
Set manual calibration. Refer to Manual Calibration for details.
-
Set auto calibration. Refer to Auto Calibration for details.
-
Set GPS calibration. Refer to GPS Coordinate Calibration for details.
Note
The supported calibration modes vary with different models. The actual device prevails.
3.2.1 Manual Calibration
Steps
1. Click Coordinate Calibration.
2. Select Calibration Mode as Manual Calibration.
Radar-Assisted Smart Monitoring Camera User Manual
19