HIKVISION iDS-2CD7 G0 Series, User Manual, Page: 49 / 108

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 49
8. Click Save .
Set Region Entrance Detection
Use to detect objects entering a pre-defined virtual region. If it occurs, the device can take linkage
actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance Detection .
2. Check Enable .
3. Select one
Region
. For the region settings, refer to
Draw Area
.
4. Select the detection target. Human and Vehicle are available. If the detection target is not selected, all
detected targets will be reported, including humans and vehicles.
Figure 6-6 Set Rule
5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule . For the linkage method settings, refer
to Linkage Method Settings .
7. Click
Save
.
Set Region Exiting Detection
Detects objects exiting from a pre-defined virtual region. If it occurs, the device can take linkage actions.
Steps
1. Go to
Configuration → Event → Smart Event → Region Exiting Detection
.
2. Check
Enable
.
3. Select one Region . For the detection region settings, refer to Draw Area .