HIKVISION iDS-2CD7 G0 Series, User Manual, Page: 52 / 108

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 52
Figure 6-9 Set Rule
5. Optional: Repeat the above steps to set more regions.
6. For the arming schedule settings, see Set Arming Schedule . For the linkage method settings, see
Linkage Method Settings .
7. Click
Save
.
The function is supported only by certain models. The actual display varies by model.
Draw Area
This section introduces the configuration of area.
Steps
1. Click Draw Area .
2. Click on the live view to draw the boundaries of the detection region, and right click to complete
drawing.
3. Click Save .
Click
Clear All
to clear all pre-defined areas.
Set Size Filter
This part introduces setting the size filter. Only a target whose size is between the minimum value and
maximum value is detected and triggers alarm.
Steps
1. Click Max. Size , and drag the mouse in the live view to draw the maximum target size.
2. Click Min. Size , and drag the mouse in the live view to draw the minimum target size.
3. Click
Save
.