Network Bullet Camera
·
Quick Start Guide
17
17
2.3
Installation of Water-proof Jacket
It is recommended to adopt the water-proof jacket (supplied) for the
network interface when the camera is installed outdoor.
Steps:
1.
If the network cable has been settled down, cut off the plug of the
network cable first.
2.
Route the network cable through the following components in
sequence: fix nut, water-proof ring, and the main body of the
water-proof jacket, as shown in the figure.
3.
Insert the water-proof ring into the main body of the water-proof
jacket, to increase the sealing ability of the components.
4.
Wire the plug and network cables up.
5.
Fix the O-ring to the network interface of the camera, and then
connect the network cables.
6.
Wrap the network interface with the main body of the
water-proof jacket, and then rotate the fix nut clockwise to
assemble it to the main body of the water-proof jacket.
Network Interface O-ring
Plug Water-proof Jacket Water-proof Ring Fix Nut Network Cable
Components of Water-proof Jacket