HIKVISION DS-TPM400-P, Quick Start Manual, Page: 5 / 170

English
4
Safety Instructions
 Use of the product must be in strict compliance with the local laws and
regulations. Please shut down the device in prohibited area.

Use of the product must be in strict compliance with the local electrical
safety regulations.

Use the power adapter provided by qualified manufacturer. Refer to the
product specification for detailed power requirements.
 It is recommended to provide independent power adapter for each
device as adapter overload may cause over-heating or a fire hazard.

Make sure that the power has been disconnected before you wire, install,
or disassemble the device.

DO NOT directly touch exposed contacts and components once the
device is powered up to avoid electric shock.
 DO NOT use damaged power supply devices (e.g., cable, power adapter,
etc.) to avoid electric shock, fire hazard, and explosion.

DO NOT directly cut the power supply to shut down the device. Please
shut down the device normally and then unplug the power cord to avoid
data loss.

DO NOT block the power supply equipment to plug and unplug
conveniently.

Make sure the power supply has been disconnected if the power adapter
is idle.

Make sure the device is connected to the ground firmly.

To avoid heat accumulation, good ventilation is required for a proper
operating environment.
 Store the device in dry, well-ventilated, corrosive-gas-free, no direct
sunlight, and no heating source environment.
 Avoid fire, water, and explosive environment when using the device.
 Avoid lightning strike for device installation. Install a lightning arrester if
necessary.
 Keep the device away from magnetic interference.

Avoid device installation on vibratory surfaces or places. Failure to
comply with this may cause device damage.