User Manual of DS-TME4XX Series Entrance & Exit Station
21
Chapter 6 Configuring General Parameters
6.1 Configuring Local Settings
Step 1
Enter the Local Configuration interface.
Configuration > Local
Figure 6-1
Local Configuration
Step 2
Configure the Live View Parameters, Record File Settings and Picture and Clip Settings on this
interface.
Live View Parameters
1)
Protocol
: TCP, UDP and MULTICAST are selectable. TCP is selected by default. Select UDP
when high requirement of video stream is not needed and the network is not stable. Select
MULTICAST when there are multiple users and you need to configure multicast address
before you select it.
2)
Stream Type
: Main Stream and Sub-Stream are selectable.
3)
Play Performance
: Shortest Delay and Auto are selectable. Auto is selected by default.
Auto mode considers both real time and fluency. While Shortest Delay mode has good
real-time performance but it may influence the fluency.
4)
Rules
: Enable and Disable are selectable. If you enable rules, the live view will display the
configured VCA rule lines or quadrilaterals.
5)
Image Size
: Auto-Fill, 4:3 and 16:9 are selectable.
6)
Auto Start Live View
: If you select Yes, live view will automatically starts after the device is
accessed.
