②This local mode
cannot
add the Keyfob since the security reason;
③If you add the wrong sensor to alarm panel. You can reset the panel or sensors.
For the alarm panel, you can long press the reset button.
④For the PIR sensor, you can remove the battery, long press the reset button, then
put the battery back. Waiting the sensor until the lights shining normally and loose
the button. Then it will not connect to the panel.
⑤For the Door magnetic contact, you can remove the battery, long press the reset
button, then put the battery back. Waiting the lights goes off and loose the
button. .Then it will not connect to the panel.
B. Web configuration Way:
a) Power the alarm panel and waiting it to run normally;
b) Switch the AP/Station (Mark 3) to AP mode(Mark 2).
