HIKVISION DS-K5671-3XF Series, User Manual

Page: 19 / 154

Chapter 3 Installation
3.1 Installation Environment
●
Avoid backlight, direct sunlight, and indirect sunlight.
●
For better face recognition, there should be light source in or near the installation environment.
●
Sunlight, wind, hot/cool air from air conditioner and other external factors, which may affect
surface temperature, will create the deviation of the temperature measurement. In order to get
an accurate result, make sure the device is applied indoors and windlessly (where is relatively
isolated from the outdoors). The working temperature should keep between 10 °C and 35 °C. If
there are no suitable environments for temperature measurement (the area faces the indoor
and connects the outdoor, the area at the door of the indoor environment, etc.), building a
temporary temperature measurement environment is suggested.
●
Influence Factors of Temperature Measurement:
Wind: The wind will take the heat away, which may affect the measurement result.
Sweat: The sweat will take the heat away, which may affect the measurement result.
Air Conditioner (Cool Air): If the indoor temperature is low, the surface temperature may also
lower than the actual temperature, which may affect the measurement result.
Air Conditioner (Heat) or Heating: If the indoor temperature is high, the surface temperature
may also higher than the actual temperature, which may affect the measurement result.
●
In order to make the device work properly, you should wait for 90 min after the device is
powered on.
●
For details about installation environment, see Tips for Installation Environment .
3.2 Mount With Bracket
3.2.1 Preparation before Mounting with Bracket
Make sure you have drilled holes on the turnstile. If not, follow the steps below to drill holes.
Steps
1. Use 4 screws (M3 or M4), secured by flange nuts, to install the reinforcing board on the inner
surface of the turnstile.
Note
The distance between the turnstile and the edge should be no longer than 10 mm.
2. Drill holes on the turnstile's inner surface according to the figure displayed below. And install
water-proof nut.
DS-K5671-3XF Series Face Recognition Terminal User Manual
5