Figure 4-2 DIP Switch
（
Binary 0011
）
Note
• The DIP switch No. 1 to 3 are suitable for setting the RS-485 communication address. No. 4 is for
Wiegand mode (OFF: Wiegand input, ON: Wiegand output).
• The DIP address cannot be repeated.
4.2 Install Secure Door Control Unit
Steps
1. Set the DIP of the secure door control unit according to the actual access control device
requirements.
Note
The DIP binary ranges from 0001 to 1111.
2. Drill holes on the wall or other places according to the mounting template.
Note
The minimum bearing weight of the wall or other places should be three times heavier than the
device weight.
3. Insert the provided plastic sleeve of the A4 expansion screw into the punched hole.
4. Insert the cable into the cable socket, and insert the Wiegand cable into the Wiegand interface.
Caution
If the cable needs to be connected from the side of the device, knock out the knockout hole on
one side.
5. Align the screw holes on both sides of the device with the sleeve in the wall and insert the
provided screws to fix the device.
DS-K2M061 Secure Door Control Unit User Manual
7
