Note
The device should support recording.
Alarm Output
The alarm output will be triggered for notification.
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input function.
Access Point
The door status of open, close, remain open, or remain
closed will be triggered.
Audio Play
The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
configured play mode.
8. Click Save.
When the card (configured in Step 5) swipes on the card reader
(configured in Step 6), it can trigger the linked actions
(configured in step 7).
9. Optional: After adding the device linkage, you can do one or
more of the followings:
Delete
Linkage
Settings
Select the configured linkage settings in the
device list and click Delete to delete it.
Edit Linkage
Settings
Select the configured linkage settings in the
device list and you can edit its event source
parameters, including event source and
linkage target.
7.6.4 Configure Device Actions for Person ID
You can set the access control device's linkage actions for the
specified person ID. When access control device detects the
specified person ID, it can trigger the alarm output, buzzer on
card reader, and other actions, so as to implement special
monitoring on the specified person.
Steps
Note
It should be supported by the device.
1. Click Access Control → Linkage Configuration .
2. Select the access control device from the list on the left.
3. Click Add to add a new linkage.
4. Select Person Linkage as the event source.
5. Enter the employee number or select the person from the
drop-down list.
6. Select the card reader where the card swipes.
7. In the Linkage Target area, set the property target to enable
this action.
93
