3.2 Wiring Cables
Wire the cables between controller and card reader, thus to establish the
communication
between
them.
3.2.1
Description
of Cable
The
description
of 10 cables is shown below.
Table 3-2
Description
of Cable
Color
Description
Orange
Wiegand ERR (Available for Wiegand Protocol)
Brown
Wiegand OK (Available for Wiegand Protocol)
White
Wiegand W1 (Available for Wiegand Protocol)
Green
Wiegand W0 (Available for Wiegand Protocol)
Blue
RS-485-
Yellow
RS-485+
Red
PWR (+12 VDC)
Black
GND
Gray
TAMPER Control
Purple
Beep Control (Available for Wiegand Protocol)
3.2.2 Set RS-485
Communication
Mode
Steps
1.
Set the DIP switch of No. 6 as 0.
2.
Set the DIP switch of No. 1 ~ 5 for RS-485 address and reading card mode. For details, refers to
DIP Switch
Description
.
3.
Wire the cable between controller and card reader as shown below.
DS-K1109 Series Card Reader User Manual
5
