HIKVISION DS-8508NIST, User Manual

Page: 66 / 122

User Manual of Network Video Recorder
65
Figure 9. 12 Editing Port Number
Steps:
1) Click on the External Port area of the corresponding port type, and edit the port number.
2) Click other place to finish editing.
Notes:

You can use the default port No., or change it according to actual requirements.

External Port indicates the port No. for port mapping in the router.

The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of the other
ports should be between 1 and 65535 and the value must be different from each other. If multiple devices
are configured for the UPnP™ settings under the same router, the value of the port No. for each device
should be unique.
4. Click Save to save the settings.
When the port mapping succeeded, the UPnP Status will change from Not Valid to Valid .
9.8.2 Manual Mapping
If your router does not support the UPnP
TM
function, perform the following steps to map the port manually in an
easy way.
Before you start:
Make sure the router support the configuration of internal port and external port in the interface of Forwarding.
Steps:
1. Enter the NAT Settings interface.
Configuration> Remote Configuration> Network Settings> NAT
2. Leave the Enable UPnP checkbox unchecked.
3. Edit the external port number.
Steps:
1) Click on the External Port area of the corresponding port type, and edit the port number.
2) Click other place to finish editing.
Note: The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of the
other ports should be between 1 and 65535 and the value must be different from each other. If multiple
devices are configured for the UPnP™ settings under the same router, the value of the port No. for each
device should be unique.
4. Click Save to save the settings.