Barrier Gate User Manual
19
The drill size should be matched with the attached expansion screw, and the hole depth should
meet the requirement of the expansion screw length.
3)
Put the host on the pre-confirmed position. Punch expansion screws into the bottom
holes and fasten them firmly.
3.
Install the boom pole.
1)
Install the boom pole to the main shaft mounting on the host, and fasten the screws to
make sure the boom pole does not tilt.
2)
(Optional) If support rod is needed, debug the horizontal and vertical status of the boom
pole, rotate the crank handle to set the boom pole to the horizontal position to confirm
the installation position of the support rod at the end of the boom pole, and fix the
support rod firmly with screws.
4.
Install peripheral devices.
1)
After the barrier gate installation and debug completes, wire the lines in the host and
connect the control lines of the peripheral devices according to the wiring diagram.
2)
Debug the devices.
6.3
Installation Debug
Problem
Debug Method
The boom pole is not on the
horizontal/vertical position.
1.
Unfasten the two screws on the main shaft crank arm,
and set the boom pole to the horizontal position.
2.
Learn the horizontal limit position, and fasten the
screws.
3.
Adjust the vertical position of the boom pole to
appropriate angle, and learn the vertical limit position.
The boom pole shakes during rising. The spring is too tight. Adjust the spring holes, or unfasten
the adjustment lever to adjust the spring tightness.
The boom pole shakes during falling. The spring is too loose. Adjust the spring holes, or fasten
the adjustment lever to adjust the spring tigntness.
Summary of Contents for Barrier gate
Page 1: ...Barrier Gate User Manual ...
