4.
Then you can see this page. The Add. Bit0 is the Broadcast address which means if
you choose this channel, you can control all PTZ in the same time. But if you want
to control the different PTZ, you need to set different Add. Bit for all of them. (You
should notice that this Add need to match the address on the device.)
E.g. If the SW1 switch on the PTZ 1 is 1, we need to set our Add. Bit as 1 too. And
normally the default Baud Rate is 2400. For the Protocol, you can choose the
HIKVISION. Then press OK button to save the setting. Then we have finished 1
PTZ’s setting. You also need to configure another 4
Notice: I have confirm with R&D colleague that all kinds of analog speed dome
have the DIP Switch. So you just need to find it. And make sure PTZ have the
different address and do the setting as I mentioned above.
