14
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Possible cause
Remedy
Does not move
No battery remaining.
Charge the battery.
Battery is not properly installed.
Push battery in until a click is heard.
Battery was installed with the switch pulled.
Due to activation of the safety feature.
Release the switch once and pull it again so
the tool moves.
Suddenly stopped
Overload protection circuit activated.
Remove cause of overload.
The material being mixed is viscous.
Switch from High speed to Low speed.
Heat protection circuit activated due to
overheating of the battery or the tool itself.
Allow battery and tool to fully cool down.
Switch can’t be pulled
Lock-o
ff
button is pushed in
Release the Lock-o
ff
button.
Cannot install battery
Attempting to install battery other than type
speci
fi
ed.
Use Multi Volt type battery.
0000Book̲UM36DA̲AU.indb 14
0000Book̲UM36DA̲AU.indb 14
2020/08/27 14:37:46
2020/08/27 14:37:46
