English
13
Remove the cord or plug from the power and then connect it again after
30 seconds or so. If this does not cause the pilot lamp to blink in red (every
second), please take the charger to the HiKOKI Authorized Service Center.
○
Always charge the battery at a temperature of 0°C – 40°C. A temperature of less
than 0°C will result in over charging which is dangerous. The battery cannot be
charged at a temperature higher than 40°C.
The most suitable temperature for charging is that of 20°C – 25°C.
○
Using an exhausted battery will damage the charger.
PRIOR TO OPERATION
1. Setting up and checking the work environment
Check if the work environment is suitable by following the precautions.
2. Mounting and dismounting the
fi
lter and pre
fi
lter
Before using the appliance, check that the
fi
lter is securely mounted.
(1) Remove the dust case (
Fig. 6
)
Looking at the dust case from the inlet port, turn it counterclockwise for approximately
120 degrees to align the protruding marks on the dust case and the housing, and then
pull it o
ff
.
(2) Remove the pre
fi
lter. (
Fig. 7
)
Turn the pre
fi
lter clockwise to remove it from the housing.
(3) Check the
fi
lter (
Fig. 8
)
After removing the pre
fi
lter, check to see if the
fi
lter is installed.
Also, check to see if the edges of the
fi
lter are turned up or not.
Fig. 6
Fig. 7
Remove
Tighten
Protruding marks
Dust Case
Inlet Port
Housing
Fig. 8
Filter
Pre Filter
Edge of
fi
lter folded over
Hold here
1
Turn clockwise
2
Remove
Housing
Pre Filter
NOTE
If
the
fi
lter is not properly
fi
tted, dirt or grime can enter the fan unit and cause damage or
malfunction.
000Book̲R18DA̲ChS.indb 13
000Book̲R18DA̲ChS.indb 13
2018/04/27 9:42:03
2018/04/27 9:42:03
