English
14
ADDITIONAL SAFETY WARNINGS
1. Ensure that the power source to be utilized conforms to the power requirements
speci
fi
ed on the product nameplate.
2. Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power switch is in the ON
position, the power tool will start operating immediately, which could cause a
serious accident.
3. When the work area is removed from the power source, use an extension cord of
su
ffi
cient thickness and rated capacity. The extension cord should be kept as short
as practicable.
4. Do not touch the bit during or immediately after operation. The bit becomes very
hot during operation and could cause serious burns.
5. Before starting to break, chip a wall,
fl
oor or ceiling, thoroughly con
fi
rm that such
items as electric cables or conduits are not buried inside.
6. At the start of work, con
fi
rm screw tightening.
7. When working at a highly elevated location, pay attention to articles and persons
below.
8. Wear protective shoes to protect your feet.
9. Wear a dust mask.
Do not inhale the harmful dusts generated in chiseling operation. The dust can
endanger the health of yourself and bystanders.
10. Mounting the tool
○
To prevent accidents, make sure to turn the switch o
ff
and disconnect the plug
from the receptacle.
○
When using tools such as bull points, cutters, etc., make sure to use the genuine
parts designated by our company.
○
Clean the shank portion of the bull point. Then smear the shank portion with the
grease or machine oil.
11. Be sure to grip the handle and side handle or cylinder case cover during work.
Do not hold by the grip during work. If you pull it by mistake, the bull point could
jump out.
12. RCD
The use of a residual current device with a rated residual current of 30 mA or less
at all times is recommended.
000Book̲H41MB2̲ChS.indb 14
000Book̲H41MB2̲ChS.indb 14
2018/05/17 10:55:42
2018/05/17 10:55:42
